The economic climate line of inverter MIG welders from Everlast is not short on efficiency or ability. The all new Power i-MIG 140E is a 120V powerhouse. The IGBT inverter style puts out a greater amp output with a better responsibility cycle when as compared to transformer based MIG welders. Contrast the Power i-MIG 140E to the competitors. The competitors features a transformer 140 amp MIG welder which normally has a 20% responsibility cycle at 90 amps, as well as a much much less responsibility cycle at an optimum amps which is practically never released. The new Everlast Power i-MIG 140E comes with a 35% responsibility cycle at maximum 140 Amps of power. And also it can do it while operating a lot more successfully, at a reduced amp draw. To finish the comparison, it is likewise lighter in weight as well as offers a smaller foot print without minimizing the maximum diameter wire roll dimension (8"). Its dimension as well as weight enables you to pick up the device as well as bring it right to where you require it without requiring a follow up see to your chiropractic doctor. CONSISTS OF: 10 Ft. (3m) 15 Series MIG gun Job clamp Ar/CO2 Regulator Consumable start package Minimum/Maximum: Up to maximum of 3/16" single pass steel/stainless/aluminum Up to maximum of 3/8" multiple pass steel/stainless/aluminum Minimum of 24 gauge cabability Make use of a spool gun to bond Light weight aluminum.
IGBT INVERTER // CAST ALLOY DRIVER ROLLER // 135A/21V @ 35% Duty Cycle/40º C
Spool Gun READY / Drive Roll wire size: .023"-.035" // Tweco Style Gun
Stepless control of both the wire speed and voltage. No tapped settings
Designed to be used with both 4" and 8" Wire Spools /
Standard drive rolls can feed .023"-.035" Wire diameter