Tabiger solder cleaner set, your essential tool for soldering as well as desoldering.
Product: light weight aluminum + plasic
Size of solder fool: 7.48"X0.79"
Size of solder wick: 2.2"X0.2"
Weight of solder fool: 32g
Weight of solder wick: 10g
How to Use the Desoldering Pump
? Step 1: Press the bettor down up until you listen to a click audio;
? Step 2: Heat up solder around product to be gotten rid of by using a soldering iron;
? Step 3: When the solder is liquid, place the pointer of the solder fool alongside the liquid as well as press press the trigger;
? Step 4: Repeat this process if necessary.How to Use the Solder Wick.
How to Use the Solder Wick
? Step 1: Position the wick over the solder you need get rid of and after that simply press the heated welding torch pointer onto the wick;
? Step 2: Eliminate the wick once the solder has actually been soaked up;
? Step 3: Cut off the pre-owned component of the wick;
? Step 4: Repeat this process if needed.
3 * solder fool
2 * solder wick(2.5 mm wide as well as 1.5 m in length)
?ONE-HANDED USE DESIGN? The Solder sucker with simple construction, so whether you are right or left-handed, you can using the desoldering pump by just cocking it and pressing the trigger button with one hand when you are ready.
?HIGH QUALITY AND POWERFUL SUNCTION? The solder sucker has an aluminum bronze frame and a high pressure vacuum which can remove solder from a printed circuit board effectively.
?ALLOY BRAIDED SOLDER WICK? Precision weaving solder braid with the size 2.5mm Width, 1.5m Length, it could help clean the spare solder on the pin away to avoid short circuit, especially in small, hard to reach areas.
?DURABLE DESOLDERING IRON TOOL? The body of desoldering pump is made of aluminum, which can resistance to beat, corrosion and have good heat dispersion, the desoldering wick has geometrically-precise weave with copper and rosin, which show no nicking or bending after a long time.
?A MUST-HAVE SOLDER REMOVAL KIT? The solder sucker can be used for broad place, which the solder wick can be used for small, hard to reach areas, all together can be used to correct mistakes with small boards on PCBs, remove relays and other components from printed circuit boards.